Finish milling of ductile iron with PCBN
03:59

Grey cast iron and ductile (nodular) cast iron are the two main types of cast iron used in today’s industry. The main difference is how the graphite appears. In grey cast iron, the graphite is in the form of flakes, while in ductile iron, the graphite is in the form of nodules. The composition is basically the same, but the demand for purity requires the Sulphur content to be very low in nodular iron.      


Both grey cast iron and ductile cast iron are very abrasive materials, but ductile iron is regarded as the more difficult one to machine. Ductile iron components can be various housings, shafts and other components mainly for the automotive segment.


Generally ductile iron is machined with carbide inserts, both roughing and finishing. When there are high requirements on dimensional tolerances and surface finish, PCBN can be an alternative for the finishing tool. The higher wear resistance of PCBN allows for longer tool life with maintained edge quality, resulting in superior tolerances and surface finish.


Rough milling is best done with wear resistant carbide grade. Seco’s range of milling grades for ductile cast iron include MP1500 and MK2050.




For finish milling, Seco’s CBN200C is the preferred grade. Grade CBN200C combines the optimum balance between substrate, coating and edge preparation for successful finish machining of high quality ductile iron components.

Depth of cut should be kept as low as possible, 0.1-0.3 mm. Cutting data is similar for carbide and PCBN, about 500 m/min, and feed rates will in finishing depend on surface finish requirement, but is in the range of 0.1 – 0.2 mm/tooth. Wiper technology will allow for higher feed rates while maintaining surface finish.

For more information, please contact your local Seco representative, or our PCBN team.

Author:
Henrik Sandqvist
Product Specialist SECOMAX PCBN/PCD
SECO TOOLS Shanghai CO., Ltd. Level 2, Building 8, 456 HongCao Rd., Shanghai 200233, China
Office: +86 21 5426 5849
Mobile: +86 186 167 90063
e-mail: henrik.sandqvist@secotools.com

0 kommentarer

Seco Helix™ wiper – The winning concept
05:05

Wiper technology is now an established method for decreasing cycle times and increasing productivity. However, the increased cutting forces associated with wiper inserts can sometimes create vibration and chatter.

One way to reduce cutting forces is to reduce the wiper radius. This solution will give less cutting forces but also worse surface finish.

The Seco way, named Helix™ wiper (-WZP) is a clever system of changing the angle of the chamfer at different intersections of the wiper area and nose radius. This unique and patented design allows you to enjoy all the high feed rate benefits of wiper technology in setups where in the past a wiper insert have resulted in chatter.

Helix™ wiper (-WZP) will reduce the radial cutting forces up to 30% and the surface finish will be the same as for standard wiper.

  For more information, please contact your local Seco representative, or our Advanced material (PCBN/PCD/CERAMIC) team.



Author:
Per Ola Jönander
Product Specialist SECOMAX PCBN/PCD/CERAMIC
SECO TOOLS AB
737 82 Fagersta, Sweden
Office +4622340818
Mobile +46703163555
e-mail:perola.jonander@secotools.com
0 kommentarer